Thermistor and temperature
Extra practical · 4.2 Electricity · Spec 4.2.1.4
Aim: Find out how the resistance of a thermistor changes with temperature.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Thermistor: The component you test, on long leads so it can go in the water.
- Ohmmeter (multimeter): Measures the resistance directly.
- Beaker of water: A water bath, so the thermistor is at the same temperature as the water.
- Kettle: Hot water to raise the temperature of the bath.
- Thermometer: Measures the water temperature.
Method
Show the method
- Connect the thermistor to an ohmmeter.
- Put the thermistor and a thermometer in a beaker of cold water.
- Record the temperature and the resistance.
- Add a little hot water from the kettle and stir.
- When the temperature is steady, record the temperature and resistance again.
- Repeat up to about 80 °C and plot resistance against temperature.
The variables
What is the independent variable?
Show answer
The temperature
You change the temperature of the water.
What is the dependent variable?
Show answer
The resistance of the thermistor
You read the resistance on the ohmmeter.
Why stir the water before each reading?
Show answer
So the water is the same temperature all through
The thermistor and the thermometer must be at the same temperature.
Remember
- Thermistor: resistance decreases as temperature increases (NTC).
- LDR: resistance decreases as light intensity increases.
- Use a water bath, stir, and wait for the reading to settle before recording.
- Uses: thermistors in thermostats and fire alarms; LDRs in automatic night lights.
Exam-style questions
What happens to the resistance of an LDR as the light gets brighter?
Show answer
It decreases
An LDR is like a thermistor but for light.
What is the main hazard?
Show answer
Hot water could scald you
Take care pouring hot water and keep the beaker steady.
Why should you wait before taking each reading?
Show answer
So the thermistor reaches the temperature of the water
The thermistor takes a little time to warm up to the water temperature.
Play next
- 🧪 Next: DensityRequired practical 5. Find the density of a regular solid, an irregular solid and a liquid.
- 🧪 Previous: I–V characteristicsRequired practical 4. Find how the current through a resistor, a filament lamp and a diode changes with the potential difference across it.
- 🧪 All AQA GCSE Physics practicalsDo all ten required practicals, plus extra ones for each topic: kit, method, readings and exam questions.
- ❓ Ten question quiz: AQA revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: AQA revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: AQA revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ AQA GCSE Physics revisionEvery topic, with questions and answers, quizzes and crosswords.
