I–V characteristics
Required practical 4 · 4.2 Electricity · Spec 4.2.1.4
Aim: Find how the current through a resistor, a filament lamp and a diode changes with the potential difference across it.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Power supply: Drives the current. Swap its leads to get negative readings.
- Variable resistor: Lets you change the potential difference in steps.
- Ammeter: Measures the current (in series).
- Voltmeter: Measures the p.d. across the component (in parallel).
- Lamp, resistor and diode: The three components you test.
- Leads: Connect the circuit.
Method
Show the method
- Set up the power supply, variable resistor, ammeter and component in series.
- Connect the voltmeter in parallel across the component.
- Use the variable resistor to set the potential difference, then record the current.
- Change the p.d. in steps, recording the current each time.
- Swap the power supply connections and repeat to get negative values.
- Repeat for the other components and plot current against p.d. for each one.
The variables
What is the independent variable?
Show answer
The potential difference across the component
You set the p.d. with the variable resistor.
What is the dependent variable?
Show answer
The current through the component
You read the current at each p.d.
Which of these is a control variable for the resistor?
Show answer
Its temperature
A resistor only has a straight-line graph at a constant temperature.
Remember
- Resistor (constant temperature): straight line through the origin. Current ∝ p.d. (ohmic).
- Filament lamp: S-shaped curve. As it gets hotter, the resistance increases.
- Diode: current flows one way only; very high resistance in reverse.
- Ammeter in series, voltmeter in parallel. Use a variable resistor to change the p.d.; swap the supply leads for negative values.
- R = V ÷ I at any point.
Exam-style questions
How do you get the negative readings?
Show answer
Swap over the connections to the power supply
Reversing the supply reverses the current and the p.d.
Which component is ohmic (current directly proportional to p.d.)?
Show answer
A resistor at constant temperature
Its I–V graph is a straight line through the origin.
Why should you not leave the current flowing for a long time?
Show answer
The components heat up, which changes their resistance
Heating changes the resistance and spoils the results; components can also get hot enough to burn.
Play next
- 🧪 Next: Thermistor and temperatureExtra practical. Find out how the resistance of a thermistor changes with temperature.
- 🧪 Previous: Resistance of a wireRequired practical 3. Find out how the length of a wire affects its resistance.
- 🧪 All AQA GCSE Physics practicalsDo all ten required practicals, plus extra ones for each topic: kit, method, readings and exam questions.
- ❓ Ten question quiz: AQA revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: AQA revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: AQA revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ AQA GCSE Physics revisionEvery topic, with questions and answers, quizzes and crosswords.
