Reflection and refraction
Required practical 9 · 4.6 Waves · Spec 4.6.1.3
Aim: Investigate how light reflects off a mirror and refracts through glass and water.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Ray box: Makes a thin ray of light (with a slit).
- Glass block and water box: The transparent materials you test.
- Plane mirror: For the reflection part.
- Protractor: Measures the angles from the normal.
- Pencil, ruler and paper: Draw round the block, the normal and the rays.
Method
Show the method
- Put the block on paper and draw round it.
- Draw a normal at 90° to the side of the block.
- Shine a thin ray from the ray box at the point where the normal meets the block.
- Mark the ray going in and coming out with small crosses.
- Remove the block, join the crosses, and measure the angles from the normal with a protractor.
- Repeat for other angles of incidence and other materials.
The variables
What is the independent variable?
Show answer
The angle of incidence
You choose the angle the ray hits the block at.
What is the dependent variable?
Show answer
The angle of refraction (or reflection)
You measure where the ray goes.
All angles are measured from...
Show answer
The normal
The normal is the line at 90° to the surface.
Remember
- Measure every angle from the normal (the line at 90° to the surface).
- Reflection: angle of incidence = angle of reflection.
- Refraction: light bends towards the normal going into a denser material (it slows down) and away from it coming out.
- Use a thin ray in a dim room; mark rays with crosses; the ray box gets hot.
Exam-style questions
What happens to a ray that hits the block along the normal (angle of incidence 0°)?
Show answer
It goes straight through without bending
It still slows down, but it does not change direction.
Why use a thin ray of light?
Show answer
So the angles can be measured more accurately
A wide beam makes it hard to mark the centre of the ray.
What is the main hazard and how do you control it?
Show answer
The ray box gets hot: do not touch the bulb and let it cool
Work in a dim room but keep the floor clear so no one trips.
Play next
- 🧪 Next: Infrared radiationRequired practical 10. Find out how the type of surface affects the infrared radiation it gives out (emits).
- 🧪 Previous: Waves in a ripple tankRequired practical 8. Measure the wavelength and frequency of water waves and use them to find the wave speed.
- 🧪 All AQA GCSE Physics practicalsDo all ten required practicals, plus extra ones for each topic: kit, method, readings and exam questions.
- ❓ Ten question quiz: AQA revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: AQA revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: AQA revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ AQA GCSE Physics revisionEvery topic, with questions and answers, quizzes and crosswords.
