Resistance of a wire
Required practical 3 · 4.2 Electricity · Spec 4.2.1.3
Aim: Find out how the length of a wire affects its resistance.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Resistance wire: The wire you test, taped along a metre rule.
- Metre rule: Measures the length of wire between the clips.
- Power supply: Drives a current through the wire (use a low p.d.).
- Ammeter: Measures the current through the wire (in series).
- Voltmeter: Measures the potential difference across the wire (in parallel).
- Leads and crocodile clips: Connect the circuit and let you change the length.
Method
Show the method
- Tape the wire along a metre rule and attach a crocodile clip at the 0 cm mark.
- Connect the circuit: ammeter in series with the wire, voltmeter across the wire.
- Put the second crocodile clip 10 cm along the wire and switch on.
- Read the ammeter and voltmeter, then switch off so the wire does not heat up.
- Move the clip 10 cm further along and repeat, up to 100 cm.
- Calculate R = V ÷ I for each length and plot resistance against length.
The variables
What is the independent variable?
Show answer
The length of the wire
You change the length by moving the clip.
What is the dependent variable?
Show answer
The resistance (from V and I)
You work out the resistance from the meter readings.
Which of these is a control variable?
Show answer
The thickness and material of the wire
A thicker wire or a different metal would change the resistance.
Remember
- R = V ÷ I. Ammeter in series, voltmeter in parallel across the wire.
- Resistance is directly proportional to length: a straight line through (0, 0) if there were no extra resistance.
- Switch off between readings: a hot wire has a higher resistance.
- Series: R total = R1 + R2. Parallel: the total is less than the smallest resistor.
- A line that misses (0, 0) by the same amount every time shows a systematic error (clips and leads).
Exam-style questions
Why should you switch off between readings?
Show answer
A current heats the wire, and a hotter wire has a higher resistance
Keeping the temperature the same makes it a fair test.
Two 10 Ω resistors are connected in series. What is the total resistance?
Show answer
20 Ω
In series, R total = R1 + R2.
Two 10 Ω resistors are connected in parallel. What is the total resistance?
Show answer
Less than 10 Ω (it is 5 Ω)
Adding resistors in parallel reduces the total resistance: it is less than the smallest one.
Play next
- 🧪 Next: I–V characteristicsRequired practical 4. Find how the current through a resistor, a filament lamp and a diode changes with the potential difference across it.
- 🧪 Previous: Efficiency of a bouncing ballExtra practical. Find out what fraction of a ball’s gravitational potential energy is still there after one bounce.
- 🧪 All AQA GCSE Physics practicalsDo all ten required practicals, plus extra ones for each topic: kit, method, readings and exam questions.
- ❓ Ten question quiz: AQA revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: AQA revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: AQA revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ AQA GCSE Physics revisionEvery topic, with questions and answers, quizzes and crosswords.
