Rates of reaction: gas volume
Required practical 11 · 5.6 Chemistry: The rate and extent of chemical change · Spec 5.6.1.2
Aim: Find out how the concentration of hydrochloric acid affects the rate of its reaction with magnesium, by measuring the volume of hydrogen made.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Gas syringe: Collects the hydrogen and measures its volume.
- Conical flask, bung and delivery tube: The reaction happens in the flask; the gas goes along the tube to the syringe.
- Measuring cylinder: Measures 50 cm³ of acid each time.
- Hydrochloric acid at different concentrations: The independent variable.
- Magnesium ribbon (3 cm strips): The same length each time.
- Stopwatch: Time the readings of the syringe.
- Safety goggles: Protect your eyes from acid spray.
Method
Show the method
- Measure 50 cm³ of hydrochloric acid into a conical flask.
- Connect the bung and delivery tube to a gas syringe pushed fully in.
- Add a 3 cm strip of magnesium ribbon, put the bung in straight away and start the stopwatch.
- Record the volume of gas in the syringe at regular times.
- Stop when no more gas is being made.
- Repeat with different concentrations of acid, using the same length of magnesium.
The variables
What is the independent variable?
Show answer
The concentration of the acid
You change the acid concentration.
What is the dependent variable?
Show answer
The volume of hydrogen made over time
The volume in the syringe at each time.
Which of these is a control variable?
Show answer
The length of magnesium ribbon and the volume of acid
Temperature should also stay the same.
Remember
- Mean rate = quantity of product (or reactant used) ÷ time, e.g. cm³/s.
- Higher concentration: more particles in the same volume, so more frequent collisions, faster rate.
- Rate at a time = gradient of the tangent (Higher).
- Same length of magnesium, same volume of acid, same temperature.
- Mg + 2HCl → MgCl₂ + H₂.
Exam-style questions
Why do the curves level off at the same volume?
Show answer
The same mass of magnesium was used up each time, so the same amount of hydrogen was made
The magnesium is the limiting reactant: the acid is in excess.
How do you find the rate at one moment from the curve? (Higher)
Show answer
Draw a tangent and work out its gradient
The gradient of the tangent is the rate at that time.
Which is a unit for the rate of this reaction?
Show answer
cm³/s
Rate = amount of product ÷ time.
Play next
- 🧪 Next: Rates of reaction: disappearing crossRequired practical 11. Find out how the concentration of sodium thiosulfate affects the rate of its reaction with hydrochloric acid, by timing how long a cross takes to disappear.
- 🧪 Previous: Temperature changesRequired practical 10. Find how the volume of sodium hydroxide added to hydrochloric acid affects the highest temperature, and find the volume needed to neutralise the acid.
- 🧪 All AQA GCSE Combined Science: Trilogy practicalsDo all 21 Trilogy required practicals, plus extra ones for most topics: kit, method, readings and exam questions.
- ❓ Ten question quiz: AQA revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: AQA revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: AQA revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ AQA GCSE Combined Science: Trilogy revisionEvery topic, with questions and answers, quizzes and crosswords.
