Strike lines and a borehole
Extra practical · T2 Geological map applications · Spec T2.1
Aim: Draw strike lines for a coal seam on a geological map, work out its dip, and find how deep it is below a proposed borehole.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Geological map: A 1:10 000 map with contours and the outcrop of the seam.
- Ruler: Draws strike lines and measures the distances between them.
- Sharp pencil: Draws and labels the strike lines.
- Calculator: Works out the dip with tan⁻¹.
Method
Show the method
- Find two places where the seam crosses the same contour and join them: that is a strike line.
- Label the strike line with the height of that contour.
- Draw more strike lines where the seam crosses other contours.
- Measure the horizontal distance between strike lines, at right angles to them.
- Work out the dip: tan(dip) = vertical interval ÷ horizontal distance.
- Extend the strike lines to find the height of the seam below the borehole, and subtract it from the ground height.
Planning questions
What is a strike line?
Show answer
A line joining points of equal height on a geological surface
It is like a contour drawn on a bed instead of the ground.
Which way does a bed dip compared with its strike lines?
Show answer
At right angles to them, towards the lower strike lines
The bed goes down from the high strike line to the low one.
What does closer spacing of strike lines show?
Show answer
A steeper dip
The same height difference over a shorter distance means steeper.
Remember
- Strike line: joins points of equal height on a geological surface; draw it where the boundary crosses the same contour twice.
- Dip is at right angles to strike, towards lower strike lines. tan(dip) = vertical interval ÷ horizontal spacing.
- Depth to a bed at a point = ground height − bed height (from the strike lines).
- Closer strike lines = steeper dip. A bed is absent where its strike-line height is above the ground.
Exam-style questions
If the ground height is lower than the strike line height at a point, what is true?
Show answer
The bed is in the air there: it has been eroded away
Where the bed would be above the ground surface it has been removed by erosion.
What shape does a horizontal bed make on a map?
Show answer
Its outcrop follows the contours
A horizontal bed is at one height, so it runs along a contour.
How is the true thickness of a dipping bed found from its outcrop width?
Show answer
Use the dip and the outcrop width on flat ground: thickness = width × sin(dip)
On level ground, true thickness = outcrop width × sin(dip).
Play next
- 🧪 Next: Till fabric analysisExtra practical. Measure the long-axis directions of pebbles in glacial till to find which way the ice was moving.
- 🧪 Previous: Slope failure on a bedding planeExtra practical. Tilt a board with a rock block on it to find the angle at which the block slides, dry and wet, and see why slopes fail.
- 🧪 All Eduqas A-level Geology practicalsDo all 20 specified practicals (SP1 to SP20), plus extra ones for the other topics: kit, method, results and exam questions.
- ❓ Ten question quiz: Eduqas revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: Eduqas revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: Eduqas revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ Eduqas A-level Geology revisionEvery topic, with questions and answers, quizzes and crosswords.
