Slope failure on a bedding plane
Extra practical · T1 Geohazards · Spec T1.1
Aim: Tilt a board with a rock block on it to find the angle at which the block slides, dry and wet, and see why slopes fail.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Rock block: Sits on the board like a block of rock resting on a bedding plane.
- Tilting board: Its surface stands for the bedding plane; one end is raised slowly.
- Protractor: Reads the angle of the board when the block starts to slide.
- Water spray: Wets the surface for the second set of tests.
Method
Show the method
- Lay the rock block on the board with both surfaces clean and dry.
- Raise one end of the board slowly and steadily.
- Read the angle on the protractor as soon as the block starts to slide.
- Repeat five times and work out the mean angle.
- Spray water on the board and repeat the five tests.
- Use tan(angle) to work out the coefficient of friction, dry and wet.
The variables
What is the independent variable?
Show answer
Whether the surface is dry or wet
You change the surface from dry to wet.
What is the dependent variable?
Show answer
The angle at which the block slides
You measure the sliding angle.
Which is a control variable?
Show answer
The same block and board, raised at the same slow speed
Raising it faster can jerk the block and make it slide early.
Remember
- A block slides when the slope angle is more than its friction angle; coefficient of friction = tan(sliding angle).
- Wet surfaces and high pore water pressure lower the sliding angle: slopes fail after heavy rain.
- Most dangerous: planes of weakness (bedding, joints, faults) dipping out of a slope face.
- Remedies: drainage, rock bolts, netting, reducing the slope angle, toe support.
Exam-style questions
Name two ways to make a rock slope near a road safer.
Show answer
Drain the slope and pin it with rock bolts
Drainage lowers pore water pressure; bolts and netting hold blocks in place.
Why are landslides common after heavy rain?
Show answer
Water raises pore pressure and adds weight, lowering the resisting forces
Higher pore pressure reduces friction on the slip surface.
What is the factor of safety of a slope?
Show answer
Resisting forces ÷ driving forces; below 1 the slope fails
A value above 1 means the slope is stable.
Play next
- 🧪 Next: Strike lines and a boreholeExtra practical. Draw strike lines for a coal seam on a geological map, work out its dip, and find how deep it is below a proposed borehole.
- 🧪 Previous: Porosity and permeabilityExtra practical. Measure the porosity and permeability of different sediments to see which would make the best reservoir rock or aquifer.
- 🧪 All Eduqas A-level Geology practicalsDo all 20 specified practicals (SP1 to SP20), plus extra ones for the other topics: kit, method, results and exam questions.
- ❓ Ten question quiz: Eduqas revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: Eduqas revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: Eduqas revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ Eduqas A-level Geology revisionEvery topic, with questions and answers, quizzes and crosswords.
