Porosity and permeability
Extra practical · G4 Earth materials and natural resources · Spec G4.2
Aim: Measure the porosity and permeability of different sediments to see which would make the best reservoir rock or aquifer.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Sediment samples: Gravel, coarse sand, fine sand and clay-rich sand, all dry.
- Measuring cylinders: One holds 100 cm³ of sediment; the other measures the water added.
- Funnel and gauze: Holds the sediment while water drains through it.
- Stopwatch: Times how long 100 cm³ of water takes to drain through.
- Beaker: Collects the water that drains through.
Method
Show the method
- Fill a measuring cylinder to 100 cm³ with dry sediment, tapping it to settle.
- Slowly pour in water from a second cylinder until it just reaches the top of the sediment.
- Record the volume of water added: this is the pore space.
- Work out porosity = pore volume ÷ total volume × 100.
- Put the same volume of sediment in the funnel, pour 100 cm³ of water through and time how long it takes to drain.
- Repeat three times for each sediment and compare porosity and drainage time.
The variables
What is the independent variable?
Show answer
The type of sediment
You choose the sediment.
What are the dependent variables?
Show answer
The volume of water added (porosity) and the drainage time (permeability)
These are what you measure.
Which is a control variable?
Show answer
The same volume of sediment and of water each time
Using 100 cm³ each time makes the results comparable.
Remember
- Porosity = pore volume ÷ total volume × 100 (pore volume = water needed to fill the pores).
- Permeability = how easily fluids pass through: measured here by drainage time or flow rate.
- Well-sorted, rounded, coarse sediment: high porosity and permeability. Clay and cement reduce permeability.
- Good reservoirs and aquifers need both; a cap rock needs very low permeability.
Exam-style questions
What makes a good reservoir rock?
Show answer
High porosity and high permeability, eg a well-sorted sandstone
It must hold fluid (porosity) and let it flow to a well (permeability).
Why does poor sorting reduce porosity?
Show answer
Small grains fill the spaces between large grains
Mixed sizes pack more tightly.
What does cementation do to a sandstone reservoir?
Show answer
Reduces both porosity and permeability
Cement minerals fill the pore spaces and throats.
Play next
- 🧪 Next: Slope failure on a bedding planeExtra practical. Tilt a board with a rock block on it to find the angle at which the block slides, dry and wet, and see why slopes fail.
- 🧪 Previous: Life or death assemblage?Extra practical. Measure and record bivalve shells in two beds to decide which is a life assemblage and which is a death assemblage.
- 🧪 All Eduqas A-level Geology practicalsDo all 20 specified practicals (SP1 to SP20), plus extra ones for the other topics: kit, method, results and exam questions.
- ❓ Ten question quiz: Eduqas revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: Eduqas revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: Eduqas revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ Eduqas A-level Geology revisionEvery topic, with questions and answers, quizzes and crosswords.
