Soil water, organic matter and bulk density
Required technique ST3 · 3.2 The physical environment · Spec 3.2.5
Aim: Measure the water content, organic matter content and bulk density of soil cores from a wood and an arable field.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Soil corer of known volume: Takes a core of soil with a known volume (250 cm³), needed for bulk density.
- Top-pan balance: Weighs the soil at each stage.
- Drying oven (105 °C): Drives off the water without burning the organic matter.
- Muffle furnace (about 500 °C): Burns off the organic matter.
- Crucible and tongs: Holds the soil in the oven and furnace.
- Desiccator: The hot soil cools in dry air, so it does not take up water before weighing.
Method
Show the method
- Push the corer into the soil to a set depth and remove a core of known volume.
- Weigh the fresh soil in a crucible of known mass.
- Dry the soil in an oven at 105 °C and reweigh until the mass stays the same.
- Heat the dry soil in a furnace at about 500 °C to burn off the organic matter.
- Let it cool in a desiccator, then reweigh.
- Calculate the water content, organic matter content and bulk density.
The variables
Why dry to constant mass?
Show answer
To be sure all the water has gone
If the mass is still falling, some water is left.
Why dry at 105 °C and not hotter?
Show answer
Hotter temperatures would start to burn the organic matter
Then the water loss would be too high.
Why is the volume of the core needed?
Show answer
To calculate bulk density (dry mass ÷ volume)
Bulk density shows how compacted the soil is.
Remember
- ST3 edaphic factors: texture, water content, organic matter content, pH, bulk density.
- Water content = (fresh − dry) ÷ fresh × 100 (dry at 105 °C to constant mass).
- Organic matter = (dry − after burning) ÷ dry × 100 (furnace about 500 °C; cool in a desiccator).
- Bulk density = dry mass ÷ core volume (g/cm³). High bulk density = compaction.
Exam-style questions
How does organic matter improve soil?
Show answer
It holds water and nutrients and helps form a crumb structure
Humus binds particles into crumbs with pores for air and water.
Why might loss on ignition overestimate organic matter?
Show answer
Some mass is lost from water bound in clay minerals or from carbonates breaking down
Not all mass lost at high temperature is organic matter.
What does a high bulk density show?
Show answer
Compacted soil with few pores, so poor drainage and aeration
Typical values: about 1.0 for woodland and 1.3 to 1.6 g/cm³ for compacted farmland.
Play next
- 🧪 Next: Soil texture by sedimentationRequired technique ST3. Find the percentages of sand, silt and clay in two soils by sedimentation, and name each texture with the soil triangle.
- 🧪 Previous: Species association and chi-squaredRequired technique ST2. Record whether heather and bracken are present in random quadrats on a moor, and use a chi-squared test to see if they are associated.
- 🧪 All AQA A-level Environmental Science practicalsPractise every sampling technique (ST1 to ST6) and the statistics: kit, method, readings and exam questions.
- ❓ Ten question quiz: AQA revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: AQA revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: AQA revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🏝️ KN Island: revision gameRun an island for 12 years (14 in Examiner mode): every choice is real Environmental Science.
- 🔗 Associations: AQA revision gameLink eight key terms on a board and say why each pair goes together.
- 5️⃣ Five Degrees: AQA revision gameGet from one term to another in five steps or fewer, with a link that makes sense at every step.
- 🗂️ AQA A-level Environmental Science revisionEvery topic, with questions and answers, quizzes and crosswords.
