AQA A-level Environmental Science · Virtual Lab

Soil texture by sedimentation

Required technique ST3 · 3.2 The physical environment · Spec 3.2.5
Aim: Find the percentages of sand, silt and clay in two soils by sedimentation, and name each texture with the soil triangle.

Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.

Revise this practical

Equipment

Show the kit
  • 2 mm soil sieve: Removes stones and gravel: texture is measured on the fine earth only.
  • Tall jar with a lid: The soil settles in water in layers.
  • Water and dispersant: Dispersant (sodium hexametaphosphate) separates clay particles stuck together.
  • Ruler: Measures the height of each settled layer.
  • Soil texture triangle: Turns the percentages of sand, silt and clay into a texture name.

Method

Show the method
  1. Sieve the soil through a 2 mm sieve to remove stones and gravel.
  2. Put the soil in a tall jar with water and a little dispersant, put the lid on and shake hard.
  3. Stand the jar on a level bench and leave it still.
  4. Measure the height of the settled layer after 1 minute (sand).
  5. Measure again after 2 hours (sand + silt) and after 2 days (sand + silt + clay).
  6. Work out the % of sand, silt and clay and use the soil triangle to name the texture.

The variables

  1. Why does sand settle first?

    Show answer

    Sand particles are the largest and heaviest

    Particle size: sand 0.05–2 mm, silt 0.002–0.05 mm, clay under 0.002 mm.

  2. Why add a dispersant?

    Show answer

    It separates clay particles that are stuck together, so they settle as clay

    Without it, clumps of clay settle as if they were silt or sand.

  3. Why must the jar be left completely still?

    Show answer

    Movement stirs the layers and stops particles settling by size

    Readings depend on particles settling only under gravity.

Remember

  • Particle sizes: sand 0.05–2 mm, silt 0.002–0.05 mm, clay under 0.002 mm. Remove stones with a 2 mm sieve.
  • Sedimentation: shake with water and dispersant; sand settles in about a minute, silt in hours, clay in days.
  • % of each = layer height ÷ total height × 100; name the texture with the soil triangle.
  • Sandy soils drain fast and hold few nutrients; clay soils hold water and nutrients but drain slowly; loams are in between.

Exam-style questions

  1. Why is loam often the best soil for farming?

    Show answer

    It drains well but still holds enough water and nutrients

    Clay holds nutrients (cations) and water; sand gives drainage and air.

  2. Why are clay soils easily waterlogged?

    Show answer

    The tiny particles leave very small pores, so water drains slowly

    Waterlogged soils are anaerobic: roots and decomposers struggle.

  3. Which other method separates sand by size?

    Show answer

    A stack of soil sieves, weighing what stays on each one

    Sieves work for sand and gravel; silt and clay are too fine, so sedimentation is used.

Play next

Share with your class

Teachers: send this page to your students. It is free and needs no sign-up.