AQA A-level Environmental Science · Virtual Lab

Bat detector and chi-squared

Required technique ST5 · 3.1 The living environment · Spec 3.1.2, MS 1.9
Aim: Use a bat detector to count bat passes along a path with lit and dark sections, and test whether bats are spread evenly with a chi-squared test.

Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.

Revise this practical

Equipment

Show the kit
  • Bat detector: Turns the ultrasound calls of bats into sounds you can hear, so each pass can be counted.
  • Map of the route in 4 sections: Two 100 m sections lit by street lights and two dark ones.
  • Watch: Each survey starts the same time after sunset and each section takes the same time.
  • Torch with a red filter: For safety and for writing; red light disturbs bats less.
  • Recording sheet: Tally the passes in each section.

Method

Show the method
  1. Mark the route into four 100 m sections: two lit by street lights and two dark.
  2. Start 20 minutes after sunset.
  3. Tune the bat detector to 45 kHz (the call frequency of common pipistrelles).
  4. Walk at a steady pace and count the bat passes in each section.
  5. Repeat the walk on 3 nights with similar weather.
  6. Add up the totals for each section and carry out a chi-squared test.

The variables

  1. Why walk at a steady pace?

    Show answer

    So the same time is spent in each section

    More time in one section would give it more passes.

  2. Why start at the same time after sunset each night (Me5)?

    Show answer

    Bat activity changes through the night

    Sample timing matters when a variable changes with time.

  3. What does the chi-squared test compare?

    Show answer

    The observed numbers with the numbers expected if bats were spread evenly

    Here it is a goodness of fit test.

Remember

  • Bat detector (ST5): converts ultrasound calls to audible sounds; tune to a species' call frequency; count passes.
  • Chi-squared goodness of fit: E = total ÷ number of categories; χ² = Σ (O − E)²/E; df = categories − 1.
  • Significant if χ² > critical value (7.815 for df = 3 at p = 0.05). Expected values must be 5 or more.
  • Same start time after sunset, steady pace, similar weather (Me5).

Exam-style questions

  1. Why must all expected values in a chi-squared test be at least 5?

    Show answer

    Small expected values make the test unreliable

    Collect more data if any expected value is below 5.

  2. Why are bat detector counts called "passes" and not "bats"?

    Show answer

    One bat may fly past several times, so passes measure activity, not numbers

    This is a limitation of the method.

  3. All UK bats are protected. What does that mean for surveys?

    Show answer

    You must not catch, handle or disturb them without a licence

    Bat detectors are non-invasive, which is why they are used.

Play next

Share with your class

Teachers: send this page to your students. It is free and needs no sign-up.