AQA GCSE Physics · Virtual Lab

Melting ice: latent heat

Extra practical · 4.3 Particle model of matter · Spec 4.3.2.3
Aim: Heat crushed ice, plot a heating curve and use it to estimate the specific latent heat of fusion of ice.

Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.

Revise this practical

Equipment

Show the kit
  • Beaker: Holds the crushed ice.
  • Crushed ice: The substance you heat. Crushed so the heater and thermometer touch it all.
  • Immersion heater: Transfers energy at a known power (100 W here).
  • Thermometer: Measures the temperature.
  • Stopwatch: Times the heating.
  • Top-pan balance: Measures the mass of ice.

Method

Show the method
  1. Measure the mass of the crushed ice.
  2. Put the ice in a beaker with the heater and a thermometer.
  3. Record the starting temperature, then switch on the heater and start the stopwatch.
  4. Stir and record the temperature every 60 seconds.
  5. Carry on until all the ice has melted and the water has warmed up.
  6. Plot temperature against time and find how long the temperature stayed at 0 °C.

The variables

  1. What is the independent variable?

    Show answer

    The time (energy supplied)

    You read the temperature at set times.

  2. What is the dependent variable?

    Show answer

    The temperature

    You measure the temperature.

  3. Which of these is a control variable?

    Show answer

    The heater power

    Keep the power the same so energy goes in at a steady rate.

Remember

  • E = m × L. Specific latent heat of fusion: solid ↔ liquid; of vaporisation: liquid ↔ gas.
  • A heating curve is flat during a change of state: the energy breaks bonds instead of raising the temperature.
  • Energy from the heater: E = P × t.
  • Stir, use crushed ice, and use a control beaker to allow for energy from the room.

Exam-style questions

  1. What is specific latent heat?

    Show answer

    The energy needed to change the state of 1 kg of a substance with no change in temperature

    Specific heat capacity is the one about raising the temperature.

  2. Why is the ice crushed?

    Show answer

    So it touches the heater and thermometer all over and melts evenly

    Big lumps leave gaps, so parts of the beaker heat at different rates.

  3. Energy from the room also melts some ice. How does this affect your value of L?

    Show answer

    It makes it too low, because more ice melts than the heater alone could melt

    A control beaker with no heater shows how much ice the room melts.

Play next

Share with your class

Teachers: send this page to your students. It is free and needs no sign-up.