Graphic log of a sequence
Specified practical 6 · F2 Surface and internal processes of the rock cycle · Spec F2.1e
Aim: Measure and describe the beds in a cliff, then draw a graphic log to scale and interpret it.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Hard hat: Protects you from falling rock near the cliff.
- Tape measure: Measures the thickness of each bed.
- Hand lens: Shows the grain size and grains in each bed.
- Grain-size card: Gives the grain size of each bed.
- Log sheet: Squared paper with a scale for the graphic log.
- Pencil: Works when the paper is damp.
Method
Show the method
- Wear a hard hat, check the tide and keep away from the foot of the cliff where rocks fall.
- Start at the lowest bed and work upwards, from the oldest bed to the youngest.
- Measure the thickness of each bed at right angles to the bedding.
- Record the rock type, grain size, colour, structures and fossils in each bed.
- Choose a vertical scale, such as 1:50, so the whole sequence fits on the log sheet.
- Draw each bed to scale, with its width showing grain size, and add standard symbols.
Planning questions
Why measure thickness at right angles to the bedding?
Show answer
That gives the true thickness, not a larger apparent thickness
Measuring at an angle across a bed makes it look thicker than it is.
Why start logging at the bottom of the sequence?
Show answer
The lowest bed is the oldest (superposition), so the log reads in time order
A log shows the beds in the order they were laid down.
On a graphic log, what does the width of each bed show?
Show answer
Its grain size
Wider means coarser, so fining-upward and coarsening-upward patterns stand out.
Remember
- Log from the base upwards; measure true thickness at right angles to the bedding.
- Vertical scale (eg 1:50 means 1 m = 20 mm); width shows grain size (mud, silt, sand, gravel).
- Use standard symbols for lithology, sedimentary structures and fossils, and mark erosion surfaces.
- Fining-upward cycles with erosive bases: river channels. Coarsening-upward: eg deltas building out.
- Safety: hard hat, check the tide, avoid the cliff foot and do not hammer near others.
Exam-style questions
Why do desiccation cracks in the mudstone matter?
Show answer
They show the mud dried out in the air, eg on a floodplain
Cracks form when wet mud shrinks as it dries, so the sediment was exposed.
Which is the best scale for logging 30 m of rock on one sheet?
Show answer
1:100
At 1:100, 30 m becomes 30 cm: big enough to show beds, small enough to fit.
Which way up does a graphic log read?
Show answer
The bottom of the log is the oldest bed
Logs follow superposition: oldest at the base, youngest at the top.
Play next
- 🧪 Next: Sandstones in thin sectionSpecified practical 7. Point count photomicrographs of sandstones to find the proportions of quartz, feldspar, rock fragments and matrix, then classify them.
- 🧪 Previous: Describing sedimentary rocksSpecified practical 5. Describe two sandstones fully: grain size, roundness, sorting and composition, then use the description to work out where they formed.
- 🧪 All Eduqas A-level Geology practicalsDo all 20 specified practicals (SP1 to SP20), plus extra ones for the other topics: kit, method, results and exam questions.
- ❓ Ten question quiz: Eduqas revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: Eduqas revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: Eduqas revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ Eduqas A-level Geology revisionEvery topic, with questions and answers, quizzes and crosswords.
