Infiltration rate and trampling
Extra practical · 3.2 The physical environment · Spec 3.2.5, MS 1.9
Aim: Measure the infiltration rate of soil on a footpath and on nearby grassland, and test the difference with a t-test.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Infiltration ring: An open-ended metal tube pushed into the soil: the water inside can only soak downwards.
- Mallet and wooden block: Drive the ring in evenly without bending it.
- Measuring jug of water: Fills the ring to a set depth.
- Ruler: Measures the depth of water in the ring.
- Stopwatch: Times the 10 minutes.
Method
Show the method
- Hammer the ring 5 cm into the soil, using the block to keep it level.
- Pour in water to wet the soil and let it drain away.
- Fill the ring with water to a depth of 100 mm and start the stopwatch.
- Measure the depth of water left after 10 minutes.
- Repeat at 6 random places on the footpath and 6 on the grassland.
- Work out the infiltration rates and compare them with a t-test.
The variables
Why wet the soil first?
Show answer
Dry soil soaks up water fast at first, which would give a false high rate
Then every test starts with damp soil.
What is the dependent variable?
Show answer
The infiltration rate
Measured as the fall in water depth per minute.
Which is a control variable?
Show answer
The starting depth of water and the time
Also drive the ring in to the same depth.
Remember
- Infiltration rate = fall in water depth ÷ time (mm/min). Wet the soil first; same starting depth and time.
- Trampling and machinery compact soil → fewer pores → less infiltration → more runoff and erosion.
- t-test compares two means of normally distributed data; df = n₁ + n₂ − 2.
- Footpath erosion is reduced by surfacing, drainage and re-routing.
Exam-style questions
How could the footpath be managed to reduce erosion?
Show answer
Surface it, add drainage channels or move walkers to a new route
Matting, steps and cross drains slow and divert runoff.
Why might infiltration rate fall during a long test?
Show answer
The soil becomes saturated, so water soaks in more slowly
Rates are compared over the same time from damp soil.
Which factor in the Universal Soil Loss Equation would trampling mainly change?
Show answer
The soil erodibility and cover (vegetation) factors
The USLE estimates soil loss from rainfall, soil, slope, cover and management.
Play next
- 🧪 Next: Wind speed and turbine powerExtra practical. Find how the power output of a model wind turbine depends on wind speed, and work out its efficiency.
- 🧪 Previous: Tüllgren funnel and soil depthRequired technique ST4. Use a Tüllgren funnel to find how the number of soil animals (mites and springtails) changes with depth.
- 🧪 All AQA A-level Environmental Science practicalsPractise every sampling technique (ST1 to ST6) and the statistics: kit, method, readings and exam questions.
- ❓ Ten question quiz: AQA revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: AQA revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: AQA revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🏝️ KN Island: revision gameRun an island for 12 years (14 in Examiner mode): every choice is real Environmental Science.
- 🔗 Associations: AQA revision gameLink eight key terms on a board and say why each pair goes together.
- 5️⃣ Five Degrees: AQA revision gameGet from one term to another in five steps or fewer, with a link that makes sense at every step.
- 🗂️ AQA A-level Environmental Science revisionEvery topic, with questions and answers, quizzes and crosswords.
