Energy from biofuels and fossil fuels
Extra practical · 3.3 Energy resources · Spec 3.3.2, 3.3.4.1
Aim: Burn bioethanol, biodiesel and paraffin to heat water, and compare the energy each releases per gram.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Spirit burners of each fuel: Each burner holds one fuel.
- Copper can (calorimeter): Holds the water; copper conducts heat well.
- Measuring cylinder: Measures 100 cm³ (100 g) of water.
- Thermometer: Measures the temperature rise of the water.
- Top-pan balance: Weighs the burner before and after to find the mass of fuel burned.
- Draught shield: Cuts heat lost to moving air.
Method
Show the method
- Put 100 cm³ of water in the copper can and measure its temperature.
- Weigh the spirit burner with its cap on.
- Clamp the can a fixed height above the burner, with a draught shield round it.
- Light the burner and stir the water until the temperature has risen by about 20 °C.
- Put the cap on to put out the flame, then reweigh the burner.
- Repeat with each fuel and calculate the energy released per gram.
The variables
Why keep the cap on when weighing?
Show answer
Stops the fuel evaporating, which would look like fuel burned
Volatile fuels like ethanol evaporate quickly.
Which is a control variable?
Show answer
The volume of water and the height of the can above the flame
Also the same can, draught shield and temperature rise.
What is the dependent variable?
Show answer
The energy released per gram of fuel
Worked out from the temperature rise and the mass burned.
Remember
- Q = m c ΔT (water: c = 4.18 J/g/°C; 1 cm³ water = 1 g). Energy per gram = Q ÷ mass of fuel burned.
- Weigh burners with caps on; draught shield; same water volume, height and temperature rise.
- Measured values are low because of heat loss and incomplete combustion.
- Energy density: paraffin > biodiesel > ethanol. Biofuels are not automatically carbon neutral.
Exam-style questions
Why is the measured energy much lower than the data-book value?
Show answer
Heat is lost to the air and the can, and combustion is incomplete
A draught shield and lid reduce, but cannot stop, heat loss.
Why are biofuels described as "carbon neutral" by some, but not others?
Show answer
Growing the crop absorbs CO₂, but farming, fertiliser and processing release more
Land-use change, such as clearing forest, can make them worse than fossil fuels.
Why does a low energy density matter for a transport fuel?
Show answer
A bigger, heavier fuel tank is needed for the same distance
Energy density is energy per unit mass or volume.
Play next
- 🧪 Next: Solar panel angleExtra practical. Measure the power from a small solar panel at different tilt angles at midday in November, and find the best angle.
- 🧪 Previous: Wind speed and turbine powerExtra practical. Find how the power output of a model wind turbine depends on wind speed, and work out its efficiency.
- 🧪 All AQA A-level Environmental Science practicalsPractise every sampling technique (ST1 to ST6) and the statistics: kit, method, readings and exam questions.
- ❓ Ten question quiz: AQA revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: AQA revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: AQA revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🏝️ KN Island: revision gameRun an island for 12 years (14 in Examiner mode): every choice is real Environmental Science.
- 🔗 Associations: AQA revision gameLink eight key terms on a board and say why each pair goes together.
- 5️⃣ Five Degrees: AQA revision gameGet from one term to another in five steps or fewer, with a link that makes sense at every step.
- 🗂️ AQA A-level Environmental Science revisionEvery topic, with questions and answers, quizzes and crosswords.
