Burning alcohols
Extra practical · 4.7 Organic chemistry · Spec 4.7.2.2
Aim: Compare the mass of each alcohol that must burn to heat 100 cm³ of water by 20 °C.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Spirit burners of four alcohols: Methanol, ethanol, propanol and butanol.
- Copper can and clamp stand: Holds the water above the flame. Copper conducts heat well.
- Measuring cylinder: Measures 100 cm³ of water.
- Thermometer: Measures the 20 °C rise.
- Balance: Weighs the burner before and after, to find the mass of alcohol burned.
- Safety goggles: Alcohols are flammable.
Method
Show the method
- Measure 100 cm³ of water into a copper can and clamp it above the spirit burner.
- Weigh the spirit burner with its cap on and record the temperature of the water.
- Take the cap off, light the burner and stir the water with the thermometer.
- When the temperature has risen by 20 °C, put the cap on to put out the flame.
- Weigh the burner (with its cap) again to find the mass of alcohol burned.
- Repeat with each alcohol, using fresh cold water and the same distance from flame to can.
The variables
What is the independent variable?
Show answer
The alcohol burned
You compare four alcohols.
What is the dependent variable?
Show answer
The mass of alcohol burned to heat the water by 20 °C
The temperature rise is kept the same (20 °C).
Which of these is a control variable?
Show answer
The volume of water and the distance from flame to can
Both change how much energy reaches the water.
Remember
- Alcohols (–OH) burn in air: complete combustion gives carbon dioxide and water.
- Same volume of water, same temperature rise, same distance from the flame.
- Mass burned = start − end mass (cap on to stop evaporation).
- Longer chains release more energy per gram; heat losses make measured values low.
Exam-style questions
What does complete combustion of ethanol make?
Show answer
Carbon dioxide and water
C₂H₅OH + 3O₂ → 2CO₂ + 3H₂O.
What is the functional group of the alcohols?
Show answer
–OH
–COOH is the carboxylic acids; C=C is the alkenes.
Why keep the cap on the burner when weighing it?
Show answer
To stop the alcohol evaporating, which would add to the mass lost
Alcohols are volatile.
Play next
- 🧪 Next: ChromatographyRequired practical 6. Use paper chromatography to separate the dyes in an unknown ink, identify them and work out their Rf values.
- 🧪 Previous: Rates of reaction: disappearing crossRequired practical 5. Find out how the concentration of sodium thiosulfate affects the rate of its reaction with hydrochloric acid, by timing how long a cross takes to disappear.
- 🧪 All AQA GCSE Chemistry practicalsDo all eight required practicals, plus extra ones for each topic: kit, method, readings and exam questions.
- ❓ Ten question quiz: AQA revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: AQA revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: AQA revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ AQA GCSE Chemistry revisionEvery topic, with questions and answers, quizzes and crosswords.
