Measuring dip and strike
Specified practical 15 · F2 Surface and internal processes of the rock cycle · Spec F2.3b
Aim: Measure the dip, dip direction and strike of a bedding plane with a compass-clinometer and record them correctly.
Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.
Revise this practical
Equipment
Show the kit
- Compass-clinometer: Measures bearings (compass) and angles from the horizontal (clinometer).
- Field notebook: Records each reading.
- Base map: The dip symbol and reading are marked on it.
- Hard hat: Protects you if you are near a cliff or quarry face.
Method
Show the method
- Choose a clean, flat part of the bedding plane that is in place, not a loose block.
- Find the strike: turn the clinometer edge on the surface until it reads 0° (horizontal) and take the bearing along it.
- Turn the instrument 90° so its edge points straight down the slope and read the dip angle.
- Take the compass bearing of the direction the bed dips towards (the dip direction).
- Repeat at several places on the same surface and work out the mean.
- Record the reading as dip/dip direction, eg 25/130, and add the dip symbol to the map.
The variables
What is the independent variable?
Show answer
The place on the bedding plane where you take each reading
You choose where on the surface to measure.
What are the dependent variables?
Show answer
The dip angle and dip direction
These are what you read from the instrument.
Why take several readings on the same surface?
Show answer
Bedding planes are uneven, so a mean is more representative
One bump on the surface could give a misleading reading.
Remember
- Strike: the bearing of a horizontal line on the bedding plane. Dip: the greatest angle down from horizontal, at 90° to strike.
- Dip direction: the bearing the bed slopes down towards. Record as dip/dip direction, eg 25/130.
- Measure on beds in place (not loose blocks), take several readings, keep the compass away from metal.
- Apparent dip ≤ true dip: tan(apparent) = tan(true) × cos(angle between the section and the dip direction).
Exam-style questions
How are the strike and the dip direction related?
Show answer
They are at 90° to each other
Strike is the horizontal line on the bed; dip is measured at right angles to it, downhill.
Why is the apparent dip on a quarry face less than the true dip?
Show answer
The face is not parallel to the dip direction, so it cuts the bed at a gentler angle
Only a section parallel to the dip direction shows the true dip.
What does a dip of 0° mean?
Show answer
The beds are horizontal
Horizontal beds have no dip and no strike direction.
Play next
- 🧪 Next: Identifying fossils with a keySpecified practical 16. Observe the symmetry, skeleton and features of unknown fossils and use a key to identify them.
- 🧪 Previous: Scaled field sketchSpecified practical 14. Make a scaled, annotated field sketch of a faulted cliff exposure, using a metre rule as a scale object to measure features.
- 🧪 All Eduqas A-level Geology practicalsDo all 20 specified practicals (SP1 to SP20), plus extra ones for the other topics: kit, method, results and exam questions.
- ❓ Ten question quiz: Eduqas revision gameTen quick questions from one topic or a whole course.
- ✏️ Crosswords: Eduqas revision gameFive per topic. Fill in the grid, then check your answers.
- 🃏 Pairs: Eduqas revision gameMatch each question card to its answer card. Pick your topics, how many cards and how hard.
- 🗂️ Eduqas A-level Geology revisionEvery topic, with questions and answers, quizzes and crosswords.
