Eduqas A-level Geology · Virtual Lab

Densities of Earth’s layers

Specified practical 18 · F4 Earth structure and global tectonics · Spec F4.1a
Aim: Measure the densities of granite, basalt and peridotite by weighing them in air and in water, and link them to Earth’s layers.

Do it in the virtual lab: choose the kit, plan the method, take your own readings, then use your results and answer exam questions. Every run gives new readings.

Revise this practical

Equipment

Show the kit
  • Rock samples: Granite (continental crust), basalt (oceanic crust) and peridotite (upper mantle).
  • Spring balance: Weighs each sample hanging in air and then hanging in water (reads in grams).
  • Beaker of water: Deep enough for the sample to hang fully under water.
  • Cotton thread: Hangs the sample from the balance.

Method

Show the method
  1. Hang the rock sample from the spring balance with thread and record its mass in air.
  2. Lower it into the beaker of water until it is fully under water, not touching the sides or bottom.
  3. Record the apparent mass in water.
  4. Work out the volume: mass in air − mass in water = mass of water displaced, which in grams equals the volume in cm³.
  5. Work out density = mass in air ÷ volume.
  6. Repeat three times for each rock, then compare with the densities of Earth’s layers.

The variables

  1. What is the independent variable?

    Show answer

    The type of rock

    You choose which rock to test.

  2. What is the dependent variable?

    Show answer

    The density of the rock

    Density is worked out from your two readings.

  3. Which is a control variable?

    Show answer

    The sample hangs fully under water without touching the beaker

    If it touches the beaker or is not fully under, the reading in water is wrong.

Remember

  • Archimedes method: volume = mass in air − apparent mass in water (1 g water = 1 cm³). Density = mass in air ÷ volume.
  • Granite (continental crust) about 2.7, basalt/gabbro (oceanic crust) about 3.0, peridotite (upper mantle) about 3.3 g/cm³.
  • Mean Earth density about 5.5 g/cm³ needs a dense iron–nickel core.
  • Density differences explain isostasy, layering and why oceanic lithosphere subducts.

Exam-style questions

  1. Why does continental crust stand higher than oceanic crust?

    Show answer

    It is less dense (granite about 2.7 g/cm³ against basalt about 3.0), so it floats higher on the mantle (isostasy)

    Thick, light continental crust floats higher, like a thick block of wood.

  2. Why does oceanic lithosphere subduct but continental lithosphere usually does not?

    Show answer

    Old oceanic lithosphere is denser; continental crust is too buoyant

    Cold, old oceanic plates become dense enough to sink into the mantle.

  3. Weighing in water gives an apparent mass 140 g less than in air. What is the sample’s volume?

    Show answer

    140 cm³

    The upthrust equals the weight of water displaced: 140 g of water = 140 cm³.

Play next

Share with your class

Teachers: send this page to your students. It is free and needs no sign-up.